Dusted Crystal Frost Vinyl Privacy Frosted Window Film Glass Matte Etch Tint
Dusted Crystal Frost Vinyl Privacy Frosted Window Film Glass Matte Etch Tint. Frosted appearance with a scattering of glittery crystals to give a classy high end look from both inside and out. Ideal for bathroom windows, shower screens, partitions etc.
Gives total privacy, you can not see in or out. Still allows a good level of natural light through the window. Professional quality - used by most professional tint shops. Prevents UV light for skin conditions and fading of fabrics etc.
NEW Anti-bubble Frost - Exactly the same as standard frost but easier to fit with new special air escape technology. This means once you have squeegeed the film out during fitting if you make a mistake any air bubbles will disappear over a period of 14 days as any air that is trapped under the film is slowly released. We recommend if you do get bubbles you try to make them as small as possible so that the time it takes them to disappear is reduced. (Please note just because the standard is not bubble free this does not mean you will get bubbles, if you follow the instructions properly and do not make a mistake you will get a bubble free finish with the standard too).
Protection release liner, disposable after installation. Free courier is for UK mainland only and does not cover Northern Ireland, Southern Ireland, any other offshore islands and the Scottish highlands. With all films bought you will receive full fitting instructions on paper. IMPORTANT :- Applications are NOT RECOMMENDED in the following situations:- When outside temperatures are below freezing or in very bright direct sunlight. To rough cast glass surfaces.
Some airborne dust may get under the film, but this is difficult to avoid completely & it's presence will not affect the performance of the installation. DURING DRYING OUT some haziness will be evident & this will disappear & dry out over a 2-4 week period. CLEANING as you would for normal windows but not until 2 weeks after installation & always with a soft leather or cloth and clean water, never use any abrasive cleaners or cleaners that contain amonia.
Make up the slip solution in spray bottle (1 tsp washing up liquid to 1 pint cold water). Thoroughly wash glass with slip solution & squeegee dry.Remove paint, varnish or other foreign matter with a scraper. Spray glass with slip solution & squeegee out, checking that the glass surface is very clean & dust free. Window film may be cut to approximate size with a very sharp blade or scissors. It is recommended that the film be cut at least 1/2 longer & wider than the glass. You are now ready to apply the film to the glass.
Note: Separate a corner of the'window film' and liner with 2 small pieces of adhesive tape on either side of the product. Thoroughly wet the glass with the slip solution, this will hold the film in place whilst you remove the clear liner. Place film on wet glass with liner facing you. From the ready separated corner carefully peel off the liner.
Spray the film with the slip solution to give slip for the squeegee. The first stroke should be horizontal across the top of the window. The next stroke should be downwards from one edge with succeeding strokes working down and away from the first strokes.On final squeegee of the top & bottom edges the squeegee may be pushed towards the edges to remove any excess water. If a particle is trapped behind the film, carefully lift the film from the nearest corner & remove the particle. Before replacing the film, spray sufficient slip solution to thoroughly wet the glass & film. Replace the film & re-squeegee. Using a straight edge (should have about 1/8 thickness), place it on end at the edge of the window.
Reduces Fading - All Tintfit's window films help reduce fading of interior furnishings by blocking out as much as 99% of harmful and damaging ultraviolet light. The exact degree of fade reduction depends on your specific film selection, as well as the overall environment.
Visible Light Transmission - A common concern about installing window film is that it may reduce too much of the visible light so making internal areas darker. This concern is often more perception than reality. The human eye works like a camera lens.It adjusts to the loss of light and therefore compensates any major changes in light levels received by the brain. Visible Light of Film 100% - Light Perceived by Human Eye 100% Visible Light of Film 80% - Light Perceived by Human Eye 87% Visible Light of Film 60% - Light Perceived by Human Eye 82% Visible Light of Film 33% - Light Perceived by Human Eye 68% Visible Light of Film 18% - Light Perceived by Human Eye 55% Visible Light of Film 14% - Light Perceived by Human Eye 49% Visible Light of Film 0% - Light Perceived by Human Eye 0%. All of our products come with a 14 day guarantee. We do not require a return authorisation. We recommend you use an insured carrier to return the item.
If your order is damaged in any way once you receive it i. (We are unable to replace damaged goods if you have used or tried to fit them). This listing is currently undergoing maintenance, we apologise for any inconvenience caused. The item "Dusted Crystal Frost Vinyl Privacy Frosted Window Film Glass Matte Etch Tint" is in sale since Friday, June 03, 2016.
- Brand: Tintfit Window Films
- MPN: Does Not Apply
- Material: Window Film